Over-run Clutch Yoke Designed to allow high RPM implements to wind down when the tractor PTO is disengaged, protecting the drive shaft and tractor from damage, caused by the transmission of inertial loads from the implement.
Quick-Release Coupler For both tractor and implement ends. To fit standard 1 3/8" x 6 spline drive shafts. Totally secure, yet quick & easy to hitch/unhitch.
Telescopic "Bell" Shaft With a minimum end-to-end distance of 1350mm, extends to suit distance required for implement. "Bell" tube profile for moderate to heavy loads.
Fully Shielded Shaft is complete with a FULL Safety Shield. Do not operate the driveline if shielding is not in place. Shaft Guard must turn freely on the driveline.
IMPORTANT Refer to User Manual for instructions on greasing, shortening and general use.
